Owner's Manual

Page 5
SKU 93261
46095
For technical questions, please call 1-800-444-3353.
2. Hand tighten all connections if possible. If pliers are used, care must be
taken not to overtighten components as they may break. (See Figure A.)
3. Cut the end of the Hose (1 or 1A) at an angle. This will allow easier
insertion into the Faucet Hose Connector (2). Press and twist hose in 1/2
inch. (See Figure A.)
4. Route the Hose along the desired watering locations. (See Figure B.)
5. If necessary, use the Hose Nail-down Clips (12) to secure the Hose to a
wooden rail, pot, or other fixture. The Tie-down stakes can be used to
secure the Hose to dirt within the pot or on the ground.
6. Decide on how the Drip Nozzles (11 & 14) will be connected.
7. Pots over 8 inches in diameter may require 2 or more Drip Nozzles. In
planter boxes, place the Drip Nozzles every 12 inches. Main Hose runs
should not be over 50 feet in length. Hose connections to hanging plants
should not be over 10 feet in height.
8. Use Scissors to cut the Hose at the desired location and length.
9. The Hose Tees (7) can be used to tap off the main Hose line.
FIGURE B
10. Turn on the water to flush out the Hose (1 or 1A) before taping off and
closing the end(s). This will blow out any debris within the Hose.
NOTE: Do not exceed the maximum 55 PSI water pressure for the
Hose.
11. Use the Plastic Tubes (8) to close an open Hose (1 or 1A) end by