Product manual

Page 3For technical questions, please call 1-800-444-3353.Item 60449
Refer to Section 690-8 of the National
Electrical Code for an additional
multiplying factor of 125 percent (80
percent derating) which may apply.
7. Do not attach to battery or power
grid without proper regulator,
inverter, and/or charge controller.
8. Install and use according to
applicable National Electrical
Code (NEC) standards.
9. Verify that installation surface
has no hidden utility lines before
drilling or driving screws.
10. Install only according to these
instructions. Improper installation
can create hazards.
11. Wear ANSI-approved safety goggles
and heavy-duty work gloves during
installation. Do not wear jewelry or
metal watches when working near
solar panels, wiring or batteries.
12. Keep installation area clean and well lit.
13. Keep out of reach of children.
14. Keep bystanders out of the
area during installation.
15. Do not install when tired or when under
the influence of drugs or medication.
Service Precautions
1. Disconnect items being
charged before cleaning.
2. Do not allow children to play with or
near this item or electrical components.
3. Inspect before each use; do not
use if damaged, parts are loose,
water is found inside the housing,
electrical insulation is cracked or
damaged, or connections are loose.
4. Maintain product labels and nameplates.
These carry important safety information.
If unreadable or missing, contact Harbor
Freight Tools for a replacement.
5. WARNING: Handling the cord on this
product will expose you to lead, a
chemical known to the State of California
to cause cancer, and birth defects or
other reproductive harm. Wash hands
after handling. (California Health &
Safety Code § 25249.5, et seq.)
SAVE THESE INSTRUCTIONS.