Product manual

Page 18 For technical questions, please call 1-888-866-5797. ITEM 61614

SAFETY OPERATION MAINTENANCESETUP

Starting the Engine

Before starting the engine:

a. Follow the Set Up Instructions in this manual to prepare the engine.

b. Follow the Set Up Instructions in the equipment manual to prepare the equipment.

c. Inspect the equipment and engine.

d. Fill the engine with the proper amount and type of both unleaded gasoline and oil.

e. Read the Equipment Operation section in the equipment manual.

1. To start a cold engine, pull the Choke Knob out

to the START position.

To restart a warm engine, push the Choke in

to the RUN position.

2. Open the Fuel Valve, if equipped.

3. Slide the Throttle or Speed Control Lever to 1/3

away from the SLOW position (the “turtle”).

Note: Some tools have a Speed Control Lever located

elsewhere on the tool which functions the same as

the Throttle. Use the Speed Control Lever in place

of the Throttle when the tool is so equipped.

4. Insert the Key and turn it to START

until the engine starts,

no more than a few seconds.

Release the Key when the engine starts.

OFF START