Owner's Manual

NOTICE
Clean the Airbrush IMMEDIATELY after use.
Delayed or inadequate cleaning will permanently clog the Airbrush.
Page 16 For technical questions, please call 1-800-444-3353. Item 69861
SAFETY OPERATION MAINTENANCESETUP
General Troubleshooting Chart
Problem Possible Causes Likely Solutions
Poor Paint
Atomization
1. Low paint level.
2. Paint not properly thinned.
3. Clogged Nozzle.
4. Loose/damaged Needle.
1. Refill.
2. Thin paint.
3. Clean Nozzle.
4. Adjust or replace Needle.
Will Not Spray 1. No pressure at Airbrush.
2. Air Pressure Valve not open enough.
1. Check air hoses.
2. Open Air Pressure Valve.
Overspray
(Paint drifting
to unintended
objects.)
1. Improper application speed.
2. Improper distance from workpiece.
3. Too much air pressure.
1. Move moderately and parallel.
2. Adjust distance.
3. Reduce air pressure.
Nozzle Leakage 1. Dirty Nozzle.
2. Worn or damaged Nozzle.
1. Clean Nozzle.
2. Replace Nozzle and/or Needle.
Air Leaking
from Nozzle
1. Dirty air valve/seat.
2. Sticking air valve.
3. Damaged air valve spring.
4. Worn/damaged air valve/seat.
1. Clean air valve/seat.
2. Lubricate air valve/seat.
3. Replace air valve spring.
4. Replace air valve.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect air supply before service.