Product manual

Page 12 For technical questions, please call 1-888-866-5797. Item 98265
SAFETY OPERATION MAINTENANCESETUP
Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical outlet
before performing any procedure in this section.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1� BEFORE EACH USE, inspect the general
condition of the tool� Check for:
• loose hardware,
• misalignment or binding of moving parts,
• cracked or broken parts,
• damaged electrical wiring, and
• any other condition that may
affect its safe operation�
2� AFTER USE, wipe external surfaces of the tool
with clean cloth� Drain water from the water tray
and wash out any residue from the sump pump�
3� WARNING! If the supply cord of this
power tool is damaged, it must be replaced
only by a qualified service technician.
Cleaning the Saw
1� With the saw turned off and the cord pulled out
from the outlet, wipe down all of the external parts
of the unit with a damp (not dripping wet) sponge�
2� Make sure that the Water Tray is also cleaned and
a container of some type is located below the Drain
Plug (E03)� Remove the plug and drain the water
and silt accumulated by the cutting operation�
3� Use more water to clean out the
residual silt from the water tray�
4� Replace the Drain Plug� Check condition of
the O-Ring (E02) and replace if torn or cut�
5� The cleaning process is faster and easier
if the unit is tipped on end and carefully
(do not wet the motor) hosed down�
6� Wipe the entire unit down including the
sides and Sliding Bars (C16)�
7� Clean out the pump by removing the Filter (A26),
placing the pump into a container of clean water, and
running it to pump out any remaining silt� Back flush
the screen Filter (A26) and replace onto the pump�