Product manual

Page 8 For technical questions, please call 1-888-866-5797. Item 98265
SAFETY OPERATION MAINTENANCESETUP
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical outlet
before performing any procedure in this section.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual�
Assembly
1� Attach the Handle (B13) onto the Holder (B09)
turned as shown, using the two supplied
Screws (B12) and Washers (B11)� See Figure A�
Handle
(B13)
Screw (B12)
Washer (B11)
Figure A
2� Check that the water pump (A25) is properly
installed within its holding clips� See Figure B�
Holding Clips
Figure B
3� Run the water hose from the pump discharge
to the Blade Cover (A30) and connect it�
Mounting
1� Mount the tool to a workbench
or other stable surface�
2� The ideal method is to mount the tile saw on
the stand made for it (sold separately)�