Product manual

Page 14SKU 95607
For technical questions, please call 1-800-444-3353.
The Speed Control Knob (F) sets the speed of the Lathe to suit the weight of the
workpiece or the type of tool being used. After the Lathe is started, turn the Knob
(F) clockwise to increase the Spindle speed (up to maximum of 3200 RPM). See
Figure 8.
Turn the Knob (F) counterclockwise to decrease the Spindle speed (down to a
minimum of 750 RPM).
Adjust the Knob (F) until the desired workpiece rotation speed is reached.
1.
2.
3.
SPEED CONTROL OPERATION
Speed Control Knob
The Circuit Breaker Reset Button (G) will reset the Motor (H) after it shuts off
during operation due to overloading or low voltage. See Figure 8.
Turn the ON/OFF Switch (E) to the OFF position.
Wait about 5 minutes for the Motor (H) to cool.
Push the Reset Button (G).
Turn the ON/OFF Switch (E) to the ON position.
1.
2.
3.
4.
5.
Circuit Breaker Reset Button
Figure 8
F
G
E
WARNING! To prevent accidental start-up if Reset Button (G) is
pushed, the ON/OFF Switch (E) should be in OFF position and plug should
be removed from the outlet as the Motor (H) cools. Overheating may be
caused by misaligned parts or dull chisel. Inspect Lathe for proper setup
before using again.