Owner's Manual

SKU 94071 For technical questions, please call 1-800-444-3353 PAGE 9
To Attach The Eyeshield:
1. An Eyeshield must be attached
to both Right Safety Guard
(to be used as protection
from the Grinding Wheel).
2.
Eyeshield
Attach the Eyeshield to the Guard
using two Screws, two Flat Washers,
and two Spring Washers. Orient it
as shown in the illustration above.
To Mount The Grinder
On A Workbench:
CAUTION! Make sure the workbench
on which the Grinder will be mounted
is at, level, and sturdy enough to
support the weight of the Grinder, any
workpieces, and any additional tools.
1. The Grinder is equipped with four
Rubber Feet which allows the tool
to be temporarily placed upon
a workbench for use. However,
if the Grinder is to be permanently
mounted on a workbench, the
Rubber Feet must be removed.
2. To permanently mount the Grinder
on a workbench, remove the
Rubber Feet and place the Grinder
in the desired work location on
the workbench. Use the four
mounting holes at the Base as
a template to mark the areas
where four 3/16″ diameter
mounting holes should be drilled
through the workbench.
3. Temporarily remove the Grinder, and
drill the four 3/16″ diameter mounting
holes through the workbench, making
sure no hidden electric cords or
cables are in the drilling path.
4. Once the 3/16″ mounting holes
are drilled, align the four mounting
holes at the Base of the Grinder
with the four predrilled mounting
holes in the workbench. Secure
the Grinder to the workbench, using
four appropriate length Bolts, Lock
Washers, and Nuts (not included).
REV 06c; 11a