4" LED Tail Light Flange Mount Assembly & Operating Instructions

ManualsBrandsHarbor Freight Tools ManualsWork Light94795

ASSEMBLY & OPERATING INSTRUCTIONS

3491 Mission Oaks Blvd., Camarillo, CA 93011

Visit our Web Site at www.harborfreight.com

2006 by Harbor Freight Tools

any artwork contained herein may be reproduced in any shape or form without the

express written consent of Harbor Freight Tools.

For technical questions and replacement parts please call 1-800-444-3353.

94795

Due to continuing improvement, actual product may differ slightly from the product described herein.

4” LED TAIL LIGHT

FLANGE MOUNT

Summary of content (4 pages)

PAGE 1
4” LED TAIL LIGHT FLANGE MOUNT 94795 ASSEMBLY & OPERATING INSTRUCTIONS Due to continuing improvement, actual product may differ slightly from the product described herein. ® 3491 Mission Oaks Blvd., Camarillo, CA 93011 Visit our Web Site at www.harborfreight.com Copyright© 2006 by Harbor Freight Tools®. All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools.
PAGE 2
THANK YOU for choosing a HARBOR FREIGHT TOOLS product. For future reference, please complete the owner’s record below: Model______________ Serial No._____________ Purchase Date_______________ SAVE THE RECEIPT, WARRANTY AND THESE INSTRUCTIONS. It is important that you read the entire manual to become familiar with the unit BEFORE you begin assembly. Technical Specifications Polycarbonate Lens, ABS housing and lens ring, copper electrical terminal pins Overall Dimensions: 2” L X 5-1/5” O.D.
PAGE 3
10. Always check hardware and assembled parts after assembling. All connections should be tight and hardware tightened. 11. Make certain to follow all local laws regarding vehicles and tail lights. 12. Do not cut or rewire any part of the Tail Light or vehicle. 13 Make certain the vehicle is turned off before performing any installation, service or maintenance. 14. Harbor Freight Tools is not responsible for damage to the Light or to the vehicle which is a result of improper installation.
PAGE 4
. Each of the Terminal Pins has been marked on the rear of the Tail Light housing; Ground, Tail, and Stop/Turn. Connect each of the wires from your vehicle to the Tail Light. Make certain the ground wire, usually white, is connected to the ground Terminal Pin. WIRING DIAGRAM White Wire (Ground) Black Wire (Tail Light) Red Wire (Stop / Turn) 5. Once the wires are properly connected, reconnect the battery.