Product manual

Page 5SKU 01110
For technical questions, please call 1-800-444-3353.
UNPACKING
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number shown on the
cover of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
NOTE: For additional information regarding the parts listed in the following pages, refer to
the Assembly Diagram on page 10 of this manual.
WARNING! Make sure the Throttle Lever (20) of the Air Punch/Flange Tool is
“OFF” and the tool is disconnected from its air supply before making any adjust-
ments.
AIR SUPPLY ASSEMBLY INSTRUCTIONS
Figure 1
NOTE: For best service you should incorporate an oiler, regulator, and in-line filter (none
of which are included) as shown in Figure 1. Hoses, couplers, oilers, regulators,
and filters are all available at Harbor Freight Tools.
NOTE: If you are not using an automatic oiler system as shown in Figure 1, add a few
drops of pneumatic tool oil (not included) to the airline connection. Add a few drops
after each hour of continual operation.
Prepare a 1/4” air connector (not included) by wrapping the threads with plumbers 2.
tape before connecting to the Air Inlet (19) on the bottom of the Air Punch/Flange
Tool. Thread the Air Hose from your compressor to the Air Punch/Flange Tool at
the Air Inlet (19).
Set the air pressure on your compressor to 90 PSI. Do not exceed 90 PSI. 3.
Frequently check the air connections to make sure they remain secure. 4.