Product manual

Page 9SKU 01110
For technical questions, please call 1-800-444-3353.
TROUBLESHOOTING
Problem Possible Causes Probable Solutions
Punch/Flange will not
start
Air supply not connected.1.
Air hose/hoses not securely 2.
connected, or damaged and
leaking air.
Check, make sure air supply is 1.
properly connected to the tool.
Check all air hose and connections. 2.
if any air hose damage is found,
replace the damaged hose/hoses.
Do not apply duct tape or wraps of
any kind to the damaged area.
Punch/Flange will
not operate smoothly
when punching and/or
flanging.
Possible dirt or debris gathered in 1.
moving parts.
Make sure Anvil (9) and Clamp (1) 1.
as well as the Punch Die (3) and
Punch (6) are wiped clean of any
dirt or debris.
PARTS LIST
Part Description Q’ty
1 Clamp 1
2 Set Screw 1
3 Punch Die 1
4 Guide Bushing 1
5 Cup Spring 13
6 Punch 1
7 Screw 2
8 Plate Guard 1
9 Anvil 1
10 Oil Seal 1
11 Support Ring 1
12 O-ring 1
13 Oil Plug 1
14 O-ring 1
15 Hydraulic Cylinder 1
16 Air Cylinder 1
17 Plastic Wrap 1
18 Valve Body 1
19 Air Inlet 1
Part Description Q’ty
20 Throttle Lever 1
21 Spring Pin 1
22 O-ring 1
23 Push Rod 1
24 Spring 1
25 Valve 1
26 Spring 1
27 O-ring 1
28 Screw 1
29 O-ring 1
30 Support Ring 1
31 Hydraulic Piston 1
32 O-ring 1
33 Support Ring 2
34 Spring 1
35 Piston 1
36 O-ring 1
37 Spring Washer 1