Product manual

Page 13SKU 38471
For technical questions, please call 1-800-444-3353.
Step 2) Mark off the material as shown above. Insert the stock into the Bender to the first mark. Bend
to 90 degrees.
Step 3) You may want to set up the Bender with the Adjustable Stop for repeated bends.
Step 4) Flip the stock around and insert the end opposite the bend. Insert it to the 2nd mark and
make a 90 degree bend.
Step 5) Reverse the stock and make the 3rd bend at the 3rd mark. Repeat for the other end and
make a bend at the 4th mark.
Step 6) With a sander or grinder remove any sharp edges or rough spots.
MAKING TUBE CLAMPS
Single Tube Clamp
The following instructions are for a 1” Inner Diameter tube clamp using 4-1/2” long, 3/16” thick x 1” wide flat
stock. See Figure 7 as a reference.
Step 1) Place a 1” die on the center point hole and secure it in place with the Long Hitch Pin (#1).
Step 2) Using the Short Hitch Pin (#2), place a 1-1/2” die in the Outer Handle 2nd hole.
Step 3) Set the Square Stop Block (#3) into the 1st hole on the Ring Assembly (#10). Orient it as in B
(Figure 5 on page 8 of this manual).
Step 4)
Square Stop Block (#3)
1” Die
Center Point Hole
2”
1-1/2” Die
Outer Handle (#9)
Figure 9
Insert the flat stock into the Bender so that it extends 1-3/4” beyond the center point. Secure
the stock into position against the Square Stop Block (#3) with a clamp or vise grip.
Figure 8
1-3/4”
1-3/4”1-3/4” 1-3/4”
1st Bend
2nd 3rd
4th