Product manual

Page 20SKU 38471
For technical questions, please call 1-800-444-3353.
The Letter “F”
Two blanks are required for this letter:
• 10-1/2””
• 2-1/2”
Step 1) Using the long blank, mark off 4-9/16” in from one side.
Step 2) Make a bend to 90° at the first chalk mark.
Step 3) Weld on the 2-1/2” piece at the center of the F.
The Letter “G”
Two blanks are required for this letter:
• 14”long
• 3”long
Step 1) Using chalk, mark off 3-3/4” in from each side of the long blank. Mark off one inch on each side
as shown above.
Step 2) Set the Right Angle Bend Attachment into place.
Step 3) Set the stock in the Bender so that the Right Angle Bend Attachment will bend at the first chalk
mark. Bend to 45°.
.Step 4) Make a bend at your second chalk mark to 45°.
Step 5) Take the stock out of the Bender. Insert the second side. Repeat steps 3 and 4.
Step 6) Mark off 1” on the 3” blank.
Step 7) Set the blank into the Bender at the chalk mark. Bend to 90°.
Step 8) Weld the 1” side of the 3” piece to the bottom portion of the “G” . The longer side of the 3” blank
will form the inside part of the G.
The Letter “H”
Three blanks are required for this letter:
• 6”
• 6”
• 3-3/4”
Step 1) Weld the 3-3/4” blank to the center of each 6” blank. Make certain that both 6”
blanks are even with each other.
3-3/4” 3-3/4”1”
1st Bend2nd
3rd 4th
1st Bend
1”
1st Bend
1”