Product manual

Page 22SKU 38471
For technical questions, please call 1-800-444-3353.
The Letter “M”
Two blanks are required for this letter:
• 13-1/2”long
• 13-1/2”long
Step 1) For each blank, mark off 6” in from one side.
Step 2) Make a bend to 75° at the first chalk mark.
Step 3) Move the blank to the second mark and bend to 75°. Repeat for the second
blank.
Step 4) Tack weld the two pieces together at one end. Make certain that all four tips are level with
one another.
The Letter “N”
Three blanks are required for this letter:
• 8-1/16”long
• 6”long
• 6”long
Step 1) On the 8-1/16” blank, mark off 1” in from each side.
Step 2) Make a bend to about 73° at the first chalk mark.
Step 3) Move the blank to the second mark and bend to about 73°.
Step 4) Tack weld the one 6” piece to each end. Make certain that all three ends are
level with one another.
The Letter “O”
Two blanks are required for this letter:
• 14”long
• 3-7/8”long
Step 1) Making the letter O is essentially the same as the letter C on page 17. Using chalk, mark off
1-1/4” in from each side. Then from the first mark, mark off 2-1/2” on each side.
Step 2) From the inside mark, measure in another 1-1/4” and mark it off.
Step 3) Set the Right Angle Bend Attachment into place.
Step 4) Set the stock in the Bender so that the Right Angle Bend Attachment will bend at the
first chalk mark. Bend to 45°.
6”
6”
1st Bend
2nd
1” 1”
1st Bend
2nd
1-1/4”
1-1/4”2-1/2” 2-1/2”
1-1/4” 1-1/4”
1st Bend234 5 6