Product manual

Page 23SKU 38471
For technical questions, please call 1-800-444-3353.
Step 5) Make a bend at your second chalk mark to 45 degrees. Repeat for the third
mark.
Step 6) Take the stock out of the Bender. Insert the second side. Repeat steps 3 and 4.
Step 7) Weld the 3-7/8” piece to the open side so that a complete circle is formed.
The Letter “P”
Two blanks are required for this letter:
• 8-7/8”long
• 6”long
Step 1) Making the top portion of the letter “P” is
essentially the same as the letter C on page 17.
Using chalk, mark off 2-3/4” in from each side of the
long blank. Mark off one inch on each side.
Step 2) Set the Right Angle Bend Attachment into place.
Step 3) Set the stock in the Bender so that the Right Angle Bend Attachment will bend at the
first chalk mark. Bend to 45°.
Step 4) Move the stock to the second chalk mark and bend to 45°.
Step 5) Pull the stock out of the bender and insert the stock with the opposite end in the
bender. Make the 3rd bend at 45°.
Step 6) Slide the stock to the fourth position and bend to 45°.
Step 7) Weld on the 6” piece to form the spine of the letter.
The Letter “Q”
Four blanks are required for this letter:
• 14”long
• 3-7/8”long
• 2”long
• 3/4”long
Step 1) Refer to making the letter “O” on page 21. Using chalk, mark off 1-1/4” in from each side.
Then from the first mark, mark off 2-1/2” on each side.
Step 2) From the inside mark, measure in another 1-1/4” and mark it off.
Step 3) Set the Right Angle Bend Attachment into place.
Step 4) Set the stock in the Bender so that the Right Angle Bend Attachment will bend at the first
chalk mark. Bend to 45°.
1st Bend
2nd
3rd 4th
2-3/4”
2-3/4”
1”
1”
1st Bend
2nd
3rd
4th
1-1/4”
2-1/2”
5th 6th
1-1/4”1-1/4”
2-1/2”
1-1/4”