Product manual

Page 25SKU 38471
For technical questions, please call 1-800-444-3353.
Step 2) Set the Right Angle Bend Attachment into place.
Step 3) Set the stock in the Bender so that the Right Angle Bend Attachment will bend at the first
chalk mark. Bend to 45°.
Note: The 2nd and 5th bends are to 41°.
Step 4) Move the blank to the second mark and bend it to 41°.
Step 5) At the third mark bend to 45°.
Step 6) Remove the blank from the Bender. Flip it over and around and insert the other side. At the #4
mark, bend to 45°.
Step 7) At the fifth mark, bend to 41° only.
Step 8) Move the blank to the sixth mark and bend to 45°. Repeat for the seventh mark.
Step 9) Once more remove the blank from the Bender and insert the other side. This may
require moving the Right Angle Bend Attachment, inserting the blank and putting back on the
Right Angle Bend Attachment. Make certain that the stock is facing the correct way in the Bender.
At the #8 mark, bend to 45°.
The Letter “T”
Two blanks are required for this letter:
• 6”long
• 5-1/2”long(Youmaywanttotrydifferentlengthsforadifferentlook).
Step 1) Weld the 5-1/2” blank to the center of the 6” blank.
The Letter “U”
One blank is required for this letter:
• 14-3/4”long
Step 1) Mark off 5” from each side. After this, mark off another 1-1/4” from each side.
Step 2) Place the blank on the Bender at the first chalk mark. Bend to 45. Move the blank to the second
chalk mark and bend to 45°.
Step 3) Move the blank to the 3rd chalk mark and bend to 45°. Move the blank to the 4th mark and bend
to 45 degrees.
The Letter “V”
One blank is required for this letter:
• 13-1/2”long
Step 1) Mark off 6” in from one side.
Step 2) Make a bend to 75° at the first chalk mark.
5” 5”
1-1/4” 1-1/4”
1st Bend
2nd
3rd
4th
6”6”
1st Bend
2nd