Product manual
Page 26SKU 38471
For technical questions, please call 1-800-444-3353.
Step 3) Move the blank to the second mark and bend to 75°.
The Letter “W”
The letter “W” is formed the same way as the letter “M” on page 21.
The Letter X
Two blanks are required for this letter:
• 7-1/2”long
• 7-1/2”long
Step 1) Place a mark at the center of each blank at the 3-3/4” mark.
Step 2) Make a bend in the blank so that an angle is obvious, but so that it measures
6” when measured tip to tip. Repeat for the second blank.
Step 3) Weld the two pieces together making certain that all sides are level and equidistant.
The Letter Y
Two blanks are required for this letter:
• 9-1/2”long
• 3-3/4”long
Step 1) Measure 3-1/4” in from each side of the 9-1/2” blank.
Step 2) Insert the blank into the Bender and make bends short of 90° (around 80°) at each mark.
Step 3) Weld the 3-3/4” blank to the center of the bottom part of the “Y” which you have just formed.
The Letter Z
Three blanks are required for this letter:
• 7-1/2”long
• 4-1/2”long
• 4-1/2”long
Step 1) Measure 1” in from each side of the 7-1/2” blank.
Step 2) Place the blank onto the Bender. At the first mark, make a bend to 50°. Take out the blank and
insert the second end. At the mark, make another bend to 50°.
Step 3) Weld the 4-1/2” pieces to each side of the 7-1/2” piece. The 4-1/2” pieces should be parallel to
each other.
3-1/4”
3-1/4”
1st Bend
3-1/4” 3-1/4”
1st Bend
2nd
1” 1”
1st Bend2nd