Product manual
Page 3SKU 96997 For technical questions, please call 1-800-444-3353.
GENERAL SAFETY RULES
WARNING! Read all instructions
Failure to follow all instructions listed below may result in serious injury.
The term “power tool” in all of the warnings listed below refers to your Mini
Needle Scaler.
SAVE THESE INSTRUCTIONS
Work area safety1.
Keep work area clean and well lit. a. Cluttered or dark areas invite accidents.
Do not operate the Scaler in explosive atmospheres, such as in the presence b.
of ammable liquids, gases or dust. Power tools create sparks which may
ignite the dust or fumes.
Keep children and bystanders away while operating a power tool. c.
Distractions can cause you to lose control.
Personal safety2.
Stay alert, watch what you are doing and use common sense when operating a.
the Scaler. Do not use a power tool while you are tired or under the inuence
of drugs, alcohol or medication. A moment of inattention while operating
power tools may result in serious personal injury.
Use safety equipment. Always wear eye protection. Safety equipment such b.
as dust mask, non-skid safety shoes, hard hat, or hearing protection used for
appropriate conditions will reduce personal injuries.
Remove any adjusting key or wrench before turning the Scaler on. c. A
wrench or a key left attached to a rotating part of the power tool may result in
personal injury.
Do not overreach. Keep proper footing and balance at all times. d. This
enables better control of the Scaler in unexpected situations.
Dress properly. Do not wear loose clothing or jewelry. Keep your hair, e.
clothing and gloves away from moving parts. Loose clothes, jewelry or long
hair can be caught in moving parts.
Power tool use and care3.
Do not force the Scaler. Use the correct power tool for your application. a. The
correct power tool will do the job better and safer at the rate for which it was
designed.
Do not use the Scaler if the Throttle Lever (6) does not turn it on and off. b. Any
power tool that cannot be controlled with the Throttle Lever is dangerous
and must be repaired. When connecting the tool to the air supply, keep your
hands off the Throttle Lever to avoid accidentally starting the tool.