Product manual

Page 6SKU 96395 For technical questions, please call 1-800-444-3353.
Note: For additional information regarding the parts listed in the following pages, refer
to the Assembly Diagram on page 8 of this manual.
Wipe down the Drill Press Table before assembly as explained in the “Cleaning”
section.
2 5
7
11
5
12
Figure 1
14
4
1
1
Attach the Drill Press Fence (2) to the T-Tracks (1) using two T-Slot Bolts (7).
Thread two Knobs (5) onto the top of each T-Slot Bolt (7). See Figure 1.
If needed for use with repetitive bores, attach the Stop Block (3) to the Drill Press
Fence (2) using one T-Slot Bolt (6) and thread the Knob (5) onto the end of the
T-Slot Bolt (6). (See Assembly Diagram on page 8).
Insert the two T-Cap Nuts (8) into slots in the bottom of the Drill Press Table top
(4) and insert three Screws (9) into each T-Cap Nut (8). Mount one Full Thread
Rod (11) into each T-Cap Nut (8) and one of the Hold Down Clamps (12) onto
each of the Full Thread Rods (11). Thread one knob (5) onto each Full Thread
Rod (11) (See Figure 1 and the Assembly Diagram on page 8).
ATTACHING THE DRILL PRESS TABLE
Wipe down the surface of the drill table.
Lay the Drill Press Table (4) onto the table of your drill press and line up the drill
chuck with the Insert Block (14). The Insert Block (14) is used to prevent tear-out
from the drill bit exiting the work piece when drilling thin materials.
Tighten the Hold Down Clamps (12) by turning the Knobs (5) clockwise until the
Hold Down Clamps (12) are snug against the bottom of the drill table. Always
tighten both clamps to insure a secure connection.
1.
2.
3.
4.
1.
2.
3.