WARNING SYMBOLS AND DEFINITIONS This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. Indicates a hazardous situation which, if not avoided, will result in death or serious injury. Indicates a hazardous situation which, if not avoided, could result in death or serious injury. Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
15. This product is not intended for use in a residence or to be mounted in a cabinet. This product is not suitable for recessed installation in ceilings or on buildings. This product can cause a fire. 21. Do not operate a Light in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. A Light creates sparks which may ignite the dust or fumes. 16. Do not leave the Light unattended when it is plugged into an electrical outlet.
Grounding TO PREVENT ELECTRIC SHOCK AND DEATH FROM INCORRECT GROUNDING WIRE CONNECTION: Check with a qualified electrician if you are in doubt as to whether the outlet is properly grounded. Do not modify the power cord plug provided with the Light. Never remove the grounding prong from the plug. Do not use the Light if the power cord or plug is damaged. If damaged, have it repaired by a service facility before use.
Symbology WARNING marking concerning Risk of Eye Injury. Wear ANSI-approved safety goggles with side shields. Double Insulated Canadian Standards Association Read the manual before set-up and/or use. Underwriters Laboratories, Inc. V~ A WARNING marking concerning Risk of Fire. Do not cover ventilation ducts. Keep flammable objects away. WARNING marking concerning Risk of Electric Shock. Properly connect power cord to appropriate outlet. Volts Alternating Current Amperes n0 xxxx/min.
. Remove both Bracket Knobs (20) from the Cross Bar (19). Line up the hole in the bottom of the lamp assembly Bracket (15) with a hole on the right or left side of the Cross Bar (19). Insert a Bracket Knob (20) and tighten. Repeat for the other lamp assembly. See Figure B. 7. Pull the shipping covers off of the Power Buttons (54) on each lamp.
Parts List and Diagram Part Description 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 Handle Bolt Reflector Bolt M4x6 Washer Bolt M4x6 Washer Bulb Socket Ceramic Tube Brass Thread Fiber Tube Adjusting Knob Washer 4x20 Bushing Bracket Bolt M4x10 Washer Cross Bar Plug Cross Bar Bracket Knob Washer 6x25 Knob Stand Connection Cap Cord Clamp Screw Grommet Screw Tie Screw Junction Box Nut Qty Part 1 1 2 2 2 4 4 2 4 2 4 2 2 2 2 2 2 2 1 2 2 1 1 10 2 4 2 2 1 6 3 1 32 33
PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT.