Product manual

Metal Punch Kit

Safety Precautions and Instructions

TO PREVENT SERIOUS INJURY,

READ AND UNDERSTAND ALL WARNINGS AND INSTRUCTIONS BEFORE USE.

3491 Mission Oaks Blvd./Camarillo, CA 93011

2004 by Harbor Freight Tools

of this instruction sheet or any artwork contained herein may be reproduced in any

shape or form without the express written consent of Harbor Freight Tools.

For technical questions, please call 1-800-444-3353.

SAVE THIS INSTRUCTION SHEET. (Operation Instructions on Back.)

91201

1. This kit has sharp edges that can cut and injure you.

• Keep fingers away from the blade, especially during use.

• Keep this kit away from children.

• Do not hold the workpiece while using this kit on it. The blade may suddenly break through

causing personal injury.

2. Flying pieces, debris, smoke, or dust caused during use can injure you.

• Always wear ANSI approved safety goggles, full face shield, and dust mask/respirator

during use. If this set is used on fiberglass or similar materials, additional protective

equipment (such as a disposable painter’s jumpsuit) should also be used.

• Use this kit only on the following recommended materials:

Mild Steel-10 gauge thick or less Fiberglass-less than .08” (about

”) thick

Aluminum-15 gauge thick or less Plastic-less than .08” (about

”) thick

Use on other materials may result in chipping, breakage, personal injury, and damage

to this kit, the workpiece, and/or the tool that this kit is used with. Do not attempt to force this

kit to do the cutting work of a larger one. There are certain applications for which this kit was

designed. Do not modify this kit and do not use this kit for a purpose for which it was not intended.

3. Pieces of the tool can break off and cause injury to the eyes, injury to the face, or other injury.

• Before every use, check for any broken parts or mounting fixtures, and any other condition that may

affect proper operation. Any part that appears damaged should be carefully checked to determine that

it will operate properly and perform its intended function.

• Do not use if any blade is worn, cracked, or chipped.

• Keep this set clean and in a dry location to prevent rust, prolong the life of the tool, and help prevent

breakage.

4. Replacement parts and accessories. When servicing, use only identical replacement parts. Use of any other

parts is dangerous and will void the warranty. Only use accessories intended for use with this kit.

5. Do not use this kit if under the influence of alcohol or drugs. Read warning labels if taking prescription

medicine to determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt, do not

use this tool.

6. Stay alert. Watch what you are doing, use common sense. Do not use this kit if you are tired.

7. Read and adhere to all safety warnings and precautions in the manual for any tool used with this Kit.

PAGE 1
Metal Punch Kit 91201 Safety Precautions and Instructions ® TO PREVENT SERIOUS INJURY, READ AND UNDERSTAND ALL WARNINGS AND INSTRUCTIONS BEFORE USE. 3491 Mission Oaks Blvd./Camarillo, CA 93011 Copyright© 2004 by Harbor Freight Tools®. All rights reserved. No portion of this instruction sheet or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. For technical questions, please call 1-800-444-3353. 1. 2. 3.
PAGE 2
The warnings, cautions, and instructions discussed in this instruction sheet cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this set, but must be supplied by the operator. Operation Instructions 1. Using a drill, drill a pilot hole through the center of the location that you want the larger hole to be.