Product manual

SKU 94253-94254 For technical questions, please call 1-800-444-3353 Page 3
Installation
Mounting with Hook and Loop Tape
1. Find the Hook and Loop tape (supplied). They come attached to each other.
Pull apart the Hook and Loop sections.
2. Peel the backing off the Hook pad.
Center on the Battery Cover and press
down to adhere.
3. Clean the spot where the Light is to be
located of any dirt and grease. Peel the
backing of the Loop pad and press
down and adhere Light to the location.
4. After the Batteries (not included) are installed, press the Puck Light against
the Loop pad to secure.
Mounting with Screw
1. Remove the Back Cover by carefully pulling up on Tabs. Remove the bag of
Screws (included) located inside the Puck Light.
2. Locate the mounting location and make a pencil
mark at the center point.
3. If mounting to a wall, use appropriate screw lugs
(not included) for the screws provided. If mounting
onto other material, drilling may be required.
Caution: Avoid electrical shock. Be certain that you
are not drilling or screwing into any electrical wires
located behind the wall.
4. Screw in mounting Screw, leaving a 1/16 inch space under the screw head.
5. Place the Screw into the center hole of the Back Cover, slide the Back Cover
to the smaller portion of the hole, and tighten Screw completely.
6. After the Batteries (not included) are installed, press the Puck Light onto the
Back Cover to secure. It should snap into place.
Installing Batteries
1. Remove the Back Cover by carefully pulling up on
the Tabs.
2. Install three, new AAA 1-1/2 volt batteries into each
Puck Light. Align the + polarity on the Battery with
the + on the battery holder.
3. Snap in the Back Cover.
Tabs