Product manual

SKU 94253-94254 For technical questions, please call 1-800-444-3353 Page 4
Operation
1. Position the Puck Light by pressing on the
left or right side of the Lens to direct the light
left or right 30 degrees.
2. Turn the Puck Light base 360 degrees to
direct the light.
3. Press in on the center of the Lens once to
turn the light on at full brightness.
4. Press again for lower brightness.
5. Press a third time to turn the light off.
Troubleshooting
Symptom Probable Cause Possible Solution
No light when
Lens pushed in.
1. Batteries weak or
dead.
2. Installed batteries
incorrectly.
1. Replace batteries.
2. Reinstall batteries
paying attention to
polarity (+/-).
One LED does
not light
LED burned out. Replace Puck Light or
have a qualified
technician repair the
unit.
Maintenance
1. Remove the batteries before storing the Puck Light.
2. Immediately remove the batteries when the batteries have run down.
3. Store the Puck Light in a clean and dry location when not in use.
4. There are no customer replaceable parts on this unit.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM
IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE
BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR
THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT,
THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THat ALL REPAIRS
AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND
LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK
AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT
OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION
OF REPLACEMENT PARTS THERETO.