Cordless Saw - Bandsaw User Manual

SKU 93762 For technical questions, please call 1-800-444-3353. Page 10
To Attach The Bandsaw To The Stand:
STAND
(TOP VIEW)
MOUNTING HOLE
MOUNTING HOLE
MOUNTING HOLE
MOUNTING HOLE
MOUNTING HOLE
MOUNTING HOLE
SCREW (59)
SPRING WASHER (58)
FLAT WASHER (57)
FIGURE B
1. With additional manpower, and an
adequate lifting device, carefully set
the Bandsaw on top of the Stand as-
sembly, making sure the upper sec-
tion of the Stand ts outside the base
of the Bandsaw. (See Figure B.)
Align the 2. three threaded mounting
holes in each end at the base of
the Bandsaw with the three mount-
ing holes located at each end of the
Stand assembly. Then secure the
Bandsaw to the Stand assembly, us-
ing three Screws (59), three Spring
Washers (58), and three Flat Wash-
ers (57). (See Figure B.)
To Attach The Stock Stop Assembly:
When mounted to the Bandsaw, the 1.
adjustable Stock Stop assembly is
used to make repetitive cuts of the
same length.
FIGURE C
STOCK
STOP (157)
SOCKET HEAD
SCREW (156)
SHAFT (158)
HEX BOLT (149)
END VIEW
WITH
HAND WHEEL (171)
IN FOREGROUND
2. To attach the Stock Stop assembly,
slide the Shaft (158) into the mount-
ing hole in the Machine Bed (142),
and secure the Shaft by tightening
the Hex Bolt (149). (See Figure C)
Slide the Stock Stop (157) onto the 3.
Shaft (158), and secure by tightening
the Socket Head Screw (156).
(See Figure C.)