Cordless Saw - Bandsaw User Manual

SKU 93762 For technical questions, please call 1-800-444-3353. Page 14
OPERATING INSTRUCTIONS
CAUTION! Turn the Power Switch
(164) to its “OFF” position and un-
plug the tool from its electrical outlet
prior to making adjustments to the
tool.
To Use The Vise:
Raise the Body Frame (60) to its 1.
vertical position, and lock the Body
Frame in place with the Support Plate
(150) and Locking Pin (153).
(See Figure H.)
FIGURE K
MOVEABLE VISE PLATE (141)
HAND
WHEEL
(171)
MACHINE BED (142)
2. Open the Moveable Vise Plate (141)
to accept the piece of material to be
cut by rotating the Hand Wheel (171)
counterclockwise. (See Figure K.)
Place the workpiece on the Machine 3.
Bed (142). If the workpiece is long,
support the end. (See Figure K.)
Clamp the workpiece rmly with the 4.
Moveable Vise Plate (141) by rotat-
ing the Hand Wheel (171) clockwise.
(See Figure K.)
To Use The Quick Vise Adjustment For
An Angle Cut:
Loosen the Hex Bolt (136), and move
the Mitering Vise Plate (138) to the
threaded hole position. Adjust the
Mitering Vise Plate to the desired
angle as indicated by the Angle Scale
(165). Loosen the Hex Bolt (139),
and adjust the Moveable Vise Plate
(141) to parallel the Mitering Vise
Plate. Then, re-tighten the Hex Bolt.
(See Figure L.)
THREADED
HOLE POSITION
MITERING
VISE
PLATE
(138)
HEX BOLT
(136)
ANGLE SCALE
(165)
MOVEABLE
VISE
PLATE
(141)
HEX BOLT
(139)
FIGURE L