Product manual

Page 57For technical questions, please call 1-888-866-5797.Item 60693
2. Typical Retrieval of I/M Readiness
a. Use the Up/Down scroll button to select I/M Readiness from
Diagnostic Menu and press OK button. (See Figure 5.4)
b. Wait a few seconds while the Scan
Tool validates the PID MAP.
c. If the vehicle supports both types of tests, then both
types will be shown on the screen for selection.
……………I/M Readiness 1/2.
Since DTCs Cleared
This Drive Cycle ?
Figure 5.34
d. Use the Up/Down scroll button, as necessary,
to view the status of the MIL light (“ON” or
“OFF) and the following monitors:
For Spark Ignition (Gasoline) Engines:
• MIS -- Misfire Monitor
• FUEL -- Fuel System Monitor
• CCM -- Comprehensive Component Monitor
• EGR – EGR System Monitor
• O2S -- O2 Sensors Monitor
• CAT -- Catalyst Monitor
• EVAP -- Evaporative System Monitor
• HTR -- O2 Sensor Heater Monitor