Product manual

Page 3For technical questions, please call 1-800-444-3353.SKU 40749
Installation (All Models)
1.
Jackscrew (3)
Figure 6
Puller Body (1)
Coat Jackscrew (3) with lubricant
and thread into Puller Body (1).
2.
Figure 7
Screw Installer
(8, 10, 11 or 12)
Insert small end of appropriate
screw installer (8, 10, 11 or
12) into hole in Jackscrew
and tighten in place.
3.
Bearing (5)
Thrust Washer (6)
Figure 8
Place Bearing (5) then Thrust
Washer (6) over the Screw Installer
and up next to the Puller Body (1).
4. Insert the pilot end of the
appropriate Screw Installer through
the pulley and thread into the pump
shaft until screw Installer bottoms.
5.
Figure 9
Hold Jackscrew with a 1/2"
socket wrench (sold separately)
and turn Puller Body with a 1" or
adjustable wrench (sold separately)
until the pulley is in position.
REV 11c