Product manual

Page 2For technical questions, please call 1-800-444-3353.SKU 04876
Specications
Attachment
Type
Threaded
Capability 3/4’ to 1‑1/2”
Material Carbon Steel
Important Safety Information
1. Use only according to these
instructions. Improper assembly
and usage can create hazards.
2. Wear ANSI‑approved safety
goggles and heavy‑duty work
gloves during usage.
3. Keep area clean and well lit.
4. Keep children and other
bystanders out of the area.
5. Do not use when tired or when under
the inuence of drugs or medication.
6. Use as intended only.
7. Inspect before every use; do not
use if parts are loose or damaged.
8. Maintain product labels and
nameplates. These carry important
safety information. If unreadable or
missing, contact Harbor Freight Tools
for a replacement.
Operating Instructions
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of
this document including all
text under subheadings therein
before set up or use of
this product.
Insert Three-Pronged Jaws
1. Brace the Pilot Bearing Puller
directly over the Bearing Seat
using the Stand Legs (8), Stand
Crossbar (9) and Fixing Screws
(4). See photo on opposite page.
2. Insert the Three‑Pronged Jaws (7) into
the inner hole of the bearing case.
3. Turn the Yoke (5) by hand so that
the Tapered Tip (6) expands the jaws
outward until they are snug against the
bearing.
NOTE: Make sure the hooked tip
of each jaw is afxed underneath
the rim of the bearing case.
Extract the Bearing Case
1. Tighten the Extracting Nut (3)
until it is snug against the Stand
Crossbar. A crescent wrench (not
included) may be needed to further
tighten the Extracting Nut.
2. Turn the Handle (1) until the bearing
case is removed evenly from the
bearing seat.