Installation Sheet

Bottom Measurements Rear Bracket Measurements
NOTE: Illustrations for measurement only.
15”
A
B
2”
A
13”
1”
2”
2”
B
1-3/16”
11/32”
15/16”
1-3/4”
1-5/32”
STEP 1 - Install Base
Remove the base from the unit by releasing the slide clips. In framed cabinets, center the unit in the opening making sure the front
plywood runner is pulled tight against the back of the face frame. For frameless cabinets, place the unit within 1-1/2” of the left of the
cabinet and the front plywood runner needs to be set back 3/4”. Install with the four (4) #10 x 3/4” Pan Head Wood Screws provided in
the four pre-drilled holes in the runners.
Face frame
Front plywood
runner
IMPORTANT:
Before you begin, make sure you familiarize yourself with all the
parts and fully read the instructions.
CUSTOMER SERVICE:
Toll-free customer help line available weekdays between
7:00am and 6:00pm Central Time at 800-463-0660.
TOOLS NECESSARY:
Screw gun or Phillips screwdriver and tape measure. NOTE: If
screw gun has a clutch, set to lowest setting so as not to over
tighten and/or strip screws.
PARTS IDENTIFICATION:
A Mounting Base 1 pcs
B Base Pullout Unit 1 pcs
C #10 x 3/4” Pan Head Wood Screw 4 pcs
D #8 x 5/8” Pan Head Wood Screw 4 pcs
E #8 x 5/8” Flat Head Wood Screw 4 pcs
Drawer Base Pullout
Installation Instructions
for the DBPO Series
Part # A B
DBPO-5 2-9/16” 2-27/32”
DBPO-8 2-17/32” 1-1/4”
E
D
B
C
A
Front plywood runner
DBPO-5
DBPO-5
Pull forward
Pull out
Scan to watch the installation video
http://delivr.com/22TZY
20-7/8”
Bottom of cabinet
DBPO-8
DBPO-8