Installation Sheet

Smart Rail Storage Solution
Installation Instructions for the SRS xxx
IMPORTANT:
Before you begin, make sure you familiarize yourself with all
the parts and fully read the instructions.
CUSTOMER SERVICE:
Toll free customer help line available weekdays between
7:00am and 6:00pm Central Time at 800-463-0660.
TOOLS NECESSARY:
Screw gun, Phillips screwdriver, ¼” drill bit, tape measure
and torpedo level. NOTE: If screw gun has a clutch, set to
lowest setting so as not to over tighten and/or strip screws.
1 Hang rail 1X
2 16’ USB recharging cord (LED Version only) 1X
3 Hang cleat 2X
4 Wall anchor 6X
5 #4 x 1” at head wood screw 6X
6 Allen set screw 6X
7 Allen wrench 1X
STEP 1 - Mounting Measurements STEP 2 - Mounting Cleats
Min.19-11/16”
Min.37-1/2”
31-1/2”
Min.15-3/4”
6-
1/4”
1-3/16”
1-3/16”
4
3
5
6
7
Switch of sensor light
1
2
3
4
5
6
7
(LED Version only)
Min.19-11/16”
Min.37-1/2”
31-1/2”
Min.15-3/4”
6-
1/4”
1-3/16”
1-3/16”
4
3
5
6
7
Switch of sensor light
1
2
3
4
5
6
7
(LED Version only)
Determine the mounting location for the Smart Rail Storage
Solution and layout mounting location on the wall as shown above.
With 1/4” drill bit, drill all six holes and insert the 6 wall anchors.
Position the hang cleats over the wall anchors and install with
3 -- #4 x 1” at head wood screws in each hang cleat.
STEP 4 - Install Hang Rail STEP 5 - Installing Accessories
Min.19-11/16”
Min.37-1/2”
31-1/2”
Min.15-3/4”
6-
1/4”
1-3/16”
1-3/16”
4
3
5
6
7
Switch of sensor light
1
2
3
4
5
6
7
(LED Version only)
Min.19-11/16”
Min.37-1/2”
31-1/2”
Min.15-3/4”
6-
1/4”
1-3/16”
1-3/16”
4
3
5
6
7
Switch of sensor light
1
2
3
4
5
6
7
(LED Version only)
Place the notch in the rear of the hang rail over the cleats and
install the Allen set screws. Tighten with the provided Allen
wrench.
Install your Smart Rail Storage Solutions accessories by pivoting
the units upward while sliding into the slot on the bottom of the
rail.
SRSxxx09/22 v.1
Min.19-11/16”
Min.37-1/2”
31-1/2”
Min.15-3/4”
6-
1/4”
1-3/16”
1-3/16”
4
3
5
6
7
Switch of sensor light
1
2
3
4
5
6
7
(LED Version only)