Owner manual

Any-Weigh™ Series Bench Scales
1-2
DeviceNet™ Scale With DeviceNet™ you can use the scale to provide a
weight output to any point on a DeviceNet™ Net
-
work. This version also incorporates both the
WAVE RS AVE R
®
and C2
®
technologies. The
DeviceNet™ Scale comes with a fifteen inch mini
-
mum length pig-tail connector.
NOTE: DeviceNet™ is a trademark of the Open DeviceNet
Vendor Association.
Analog Scale The Analog Scale provides a 4-20mA output directly
proportional to the weight reading. This version offers
a low-cost, solution for bringing analog weight read
-
ings directly into a control system. The Analog Scale
requires minimal additional wiring or hardware and
comes with a 15 foot shielded 2 wire cable.