User guide

Chapter 4 - Setup
4-11
Error Return Values:
• NOTALLOWED - the TareEnable parameter is
not
set to true
• “STATUSWORD” - means the command failed
because the weight was not
stable (in motion) or
there was an A./D error.
SEQ
NUMBER
0
COMMAND#
(Hex)
1
STATUS
2
OFFSET
3
LENGTH
4
DATA
5-16
From M1 File 2
Write Non-Volatile
Command
(WRITENONVOLA
TILE)
The Write Non-Volatile Command - causes all param-
eters (including calibration constants) to be saved to
the no
n-volatile memory.
Error Return Values: None
SEQ
NUMBER
0
COMMAND#
(Hex)
1
STATUS
2
OFFSET
3
LENGTH
4
DATA
5-16
From M1 File 4
Reload Non-
Volatile
(RELOADNONVOL
ATILE)
The Reload Non-Volatile Command - causes the
weig
h module to re-read the values stored in its non-
volatile memory. Any parameters changed since the
last write non-volatile command are overwritten. this
command can be used to abort a calibration or param-
eter entry session.
Error Return Values: None
SEQ
NUMBER
0
COMMAND#
(Hex)
1
STATUS
2
OFFSET
3
LENGTH
4
DATA
5-16
From M1 File 0x10