Manual

R
EC Level 1A 1 decimal place. Must be > or = 0.
REC Time 1B Seconds, 0 decimal places. Must be > or = 0
REC Shutdown 1C 0=no, 1=yes
Shutoff Percent 1D 0 decimal places. 0-100
Total 1E Total DP
Batch Total 1F Total DP. Must be > or = 0
Low Alarm Shut
Down Rate 20 Rate DP. No limits
High Alarm Shut
Down Rate 21 Rate DP. No limits
Alarm Delay 22 Seconds, 0 decimal places. Must be > or = 0.
Rate Setpoint 23 Rate DP. Must be > or = 0, < MAX RATE.
Rate Calibration Parameters See Rate Calibration Parameters section below
REC_P_Limit 1 decimal place. Must be > 0 and < or = 100.0.
7 Rate Cal Rates (xx32) 7 rate calibration rates. All are R DP > or = 0.
0 rate 0032 0x0032 is the minimum rate
1st rate 1032 0x1032 is the next stepped rate
2nd rate 2032 0x2032 is the next stepped rate
3rd rate 3032 0x3032 is the next stepped rate
4th rate 4032 0x4032 is the next stepped rate
5th rate 5032 0x5032 is the next stepped rate
100 rate 6032 0x6032 is the MAX RATE
7 Rate Cal
Percentages
(xx33) // 7 rate calibration percents. Uses 2 decimal places. 0.00-100.00
0 Percent 0033 0x0033 is the minimum %
1st Percent 1033 0x1033 is the next stepped %
2nd Percent 2033 0x2033 is the next stepped %
3rd Percent 3033 0x3033 is the next stepped %
4th Percent 4033 0x4033 is the next stepped %
5th Percent 5033 0x5033 is the next stepped %
100 Percent 6033 0x6033 is the MAX %
End Rate Cal section
ADC Average 34 0x0034 // Read Only
STATE 35 0x0035 // read only – see mode list below
Bit 0 Idle Mode
Bit 1 Auto Mode
Bit 2 Manual Mode
Bit 3 Start Mode
Bit 4 Stop Mode
Bit 5 Shut Off Mode
Bit 6 Pause Mode
Bit 7 Rate Cal Mode
Bit 8 Refill Mode
Bit 9 Full Mode
Bit 10 Manual Hold Mode
Bit 11 Rate Cal Hold Mode
17
●
●
Chapter 4
●
●
●