Instruction Manual

Chapter 5 - Block Transfers
5-11
TABLE 5-12: BLOCK READ COMMAND NUMBER 9: CONFIGURATION OF STANDARD RS232 PORT
Block Read
Command Number
10: Sticker Value
HI 2151/20WC Only.
NOTE: Sticker Value is not used in the HI 2151/30WC
TABLE 5-13: BLOCK READ COMMAND NUMBER 10: STICKER VALUE
Word Length
bits 0 - 7 A value of 0 or 1 [0 = seven bits, 1 = eight bits*
Handshake Control
bits 8 - 15 A value of 0 or 1 (0 = Hardware, 1 = Software
*Note: Parameters are not used in the HI 2151/30WC
14
Echo
bits 0 - 7 A value of 0 or 1 (0= Off, 1 = On)
Device Address
bits 8 - 15 A value from 0 to 99
15
TOTAL NUMBER OF WORDS 6
BLOCK READ COMMAND NUMBER 9: Configuration of Standard RS232 Port
START
WORD DEFINITIONS: #WORDS WORD
BLOCK READ COMMAND NUMBER 10: Sticker Value (HI 2151/20SC Only)
START
WORD DEFINITIONS: #WORDS WORD
Command number: A value of 10 (decimal)
bit 0 0
bit 1 1
bit 2 0
bit 3 1
bit 4 0
bit 5 0
bit 6 0
bit 7 0
bits 8 - 15 Reserved for future use
10
Sticker Value
A 20 bit number in proper integer format
21
TOTAL NUMBER OF WORDS 3