Instruction Manual

HI 2151 SERIES WEIGHT CONTROLLERS REMOTE I/O OPTION
5-20
Block Write
Command Number
55: Calibration
Parameters
TABLE 5-22: BLOCK WRITE COMMAND NUMBER 55: CALIBRATION PARAMETERS
BLOCK WRITE COMMAND NUMBER 55: Calibration Parameters
START
WORD DEFINITIONS: #WORDS WORD
Command number: A value of 55 (decimal)
bit 0 1
bit 1 1
bit 2 1
bit 3 0
bit 4 1
bit 5 1
bit 6 0
bit 7 0
bit 8 - 15 Reserved for future use
10
Units of Measure:
bits 0 - 7 0 = pounds, 1 = kilograms
Decimal point position (places to right of decimal):
bits 8 - 15 A value from 0 to 4
11
Totalizer decimal point position (places to right of decimal):
bits 0 - 7 A value from 0 to 4
C2™, Second Generation Calibration
bits 8 - 15 Load Cell Count (set to zero for Hard Cal)
12
Display Graduation Size (“count by”): A value of 1,2,5,10,20,50,100,200 or 500 1 3
Motion Tolerance: A sixteen bit value representing the lower 16 bits of the 20 bit
internal weighing range
14
Zero Tolerance: A sixteen bit value representing the lower 16 bits of the 20 bit inter-
nal weighing range
15
Number of readings averaged: A value from 1 to 200 1 6
Span weight value (Use one of the following methods. Method one, with C2, Sec-
ond Generation Calibration: Use the C2 reference point when using C2 load cells.
Method two: use test weights for calibration) A 20 bit number in proper integer for-
mat
27
Scale Capacity (Full limit of scale): A 20 bit number in proper integer format 2 9
Mid-point Linearity calibration value: A 20 bit number in proper integer format 2 11
TOTAL NUMBER OF WORDS 13