User Manual

Index
Loss-in-Weight
25
Lost OK to Dispense Alarm 89
Lost OK to Fill Alarm 86
Low Level Sensor 34
LVDT and Half Bridge Load Cells/Sensors 18
M
M - Weight Reading Stops Incrementing 109
Main Board 16
Manual Button 21
Manual Mode 21
Map the Source 81
Mapped (Assigned) 81
Mapped Data 82
Mapped I/O 1, 3
Max I/O Data Capacity
9
Max. Percent (%) Field 50
Max. Weight Field 50
Maximum Target Weight Tolerance 50
Maximum Tolerance 26
-MB 5
Mean ADC Count 130
mean squared variation 122, 129, 130
Mechanical Installation 12
Mechanical Noise 3, 41
Millivolt 121
Millivolt Reading 121
Millivolt Readings 127
Min. Percent (%) Field 50
Min. Weight Field 50
Minimum Target Weight Tolerance 50
Minimum Tolerance 26
Minute-mm Field 54
Mixed Mapping 78
Mode 119
Monitor Page 49
Month-mm Field 55
Motion Error 85
Motion Tolerance 117
Motion Tolerance Field 52
Motion Tolerance Parameter 39
Motor Starters 44
Mounting Kit 11
Multiply 78
mV and Weight 121
mV and Weight Display 121
mV Reading 127
mV/V 127
mV/V and Weight 121
mV/V and Weight Display 121
N
N - Blank Screen 110
Underdispense/Overdispense Alarms 91
Neatly Bundled 17
Negate 78
NEMA 4 & 4X 12
NEMA 4X 4
No C2 Sensor 85
Non-C2 Load Point Connection 18
NONE 37
Non-Linearity 7
Normally Open 125
NOT 77
Not OK to Discharge Alarm 94
Not OK to Dispense Alarm 89
Not OK to FILL Alarm 85
Number of Cycles 1
number of graduations 39
Number of Sensors 119
O
O - Display Stuck on a Screen 111
ODD 37
Offset 78
OK to Discharge 32
OK to Discharge OFF Radio Button 53
OK to Fill Input Parameter 32
OK to Fill Timer Field 52
OK to Fill Times Out 86
OLE Technology (DCOM) 5
On-Board Diagnostics 4
On-board Help Files 3
Online Tech Support Knowledge Base 3
Operating Temperature
9
Operating Temperature Range 8
Operation/Diagnostics - Weight & Voltage Page 131
Operator ID 31
Operator ID Field 51
Options 4
Options Configuration 55
Options Menu 55
OR 77
Original Point of Removal 11, 85
Output Alarms 1
Output Relay #1 125
Output Relay Forced Closed 125
Output Table 75
Outputs 81, 82
OVER FILL 87
Over Refill Alarm 88
Overall Depth 12
OVERDISPENSE ALARM 91
OVERFILL ALARM 88
Overview of Typical Load Cell System 132
P
Panel Cutout Specifications 12
Panel Mount 21
Panel Mount (Model # HI 3010-PM 8