User Manual

Index
Set Date/Clock Parameters
54
set point value (Target Weight) 25
Set the Span Value 62
Setup Data 22
Setup Wizards 3
Setup/3/DEF Button 23
Setup/Configuration Menus 21
Short Integer 78
Siemens 6
Silicon Controlled Rectifier 126
Silicon Controlled Rectifier (SCR) 133
Simple Operator Interfaces 44
Single Speed 29
Sliding Average 41
Slotted Head Screwdriver 13
Slow Fill Proof Switch 119
Slow Fill Proof Timer 119
Slow Gate Did Not Close 91
Slow Gate Did Not Close Alarm 87
Slow Gate Did Not Open 90
Slow Gate Did Not Open Alarm 87
Small Fasteners 11, 85
Small Logic Controllers (SLC 5
Smart Diag. Ctrl 55
Smart Diagnostics 4, 127
Smart Diagnostics (-SD) Card Configuration from the
Front Panel
55
Smart Diagnostics Card 5
Smart Diagnostics Card Configuration from the PDA 55
Smart Diagnostics Card Configuration from the Web
Browser
55
Smart Diagnostics Card Menu 55
Smart Diagnostics Rear Plate 17
Smart Preact 118
SMM 4, 19
SMM (Secure Memory Module) 1
Solenoid 126
Solid State Relay 134
Solid State Relays 133
Spacers 11, 85
Span Value 62, 115
Span Weigh 63
Span Weight Field 63
Special (Command) Mapping) 78
Specifications 7
Specifications for Peripherals/Systems Components 10
Speed 118
Speed Parameter 29
Speed Pull Down Menu 50
Stability Test 4, 122, 129, 130
Stand-Alone Controller 1
Standard Interfaces 7
Standard SPST (Form A) Setpoint Relays 7
Standby Display 23, 114
Standby Mode 21
Standoffs 16
START Button 92
Start Button 21
State Logging 125
State Logging Function 125
State Logging Function ON 125
Storage Temperature Range 8
Sum 4
Support Section 1
Switch Time 29
Switch Timer 32
Switching a Light Load 133
Swivel Bracket 13
Swivel Mount 13
Swivel Mount (HI 3010-MB) 8
Swivel Mount Brackets 13
Swivel Mounted 1
Syntax 78
System Integrity Check and Fault Determination From
the Front Panel
114
System Integrity Check and Fault Determination From
the PDA
126
System Support 134
T
Tare Limit 52, 117
Tare Limit Parameter 40
Target Preact 25, 118
Target Preact Set Point 25
Target Weight 25, 117
Target Weight “Tolerance” Pull Down Menu 49
Target Weight Tolerance 26
Target Window 26, 118
Target Window (Wt-) 118
Target Window (Wt) 118
Target Window (Wt%+) 118
Target Window Weight (-) 118
Target Window Weight (%-) 118
Target Window Weight (%+) 118
Technical Support Department 1
Temperature Coefficient 8
Tension or Compression Type Load Cells 132
terminal blocks 18
Test and Data Menu 114, 120
Test Button 4
Test Channel #1 Button 131
Test Data Display 120
Test Results
FAIL
130
PASS 129
Test Weight 62
Test/9 button 127
Test/9/WXYZ Button 23
Texas Instruments 6
The Secure Memory Module 4
The WAVERSAVER
®
Parameter 41
Tied 17
Too Hi Error 85
Too Lo Error 85