User Manual

19 CHAPTER 3

Installation

NOTE: If you have one load point you must plug it into

Channel 1. If you have more than one load point

you must make sure that you plug one of the load

points into Channel 1.

Step 6. If you only have 3 load cells, do not use Channel 4.

Installation of Secure Memory Module

(SMM)

FIG. 3-20 SECURE MEMORY MODULE (SMM)

Step 7. Slide the module with the notch up into the module

housing at the rear panel. (See Fig. 3-20 & 21)

FIG. 3-21 INSTALLING THE SECURE MEMORY

MODULE

Step 8. Press the module in until it stops. Do not force the

module, it should slide in easily.

Step 9. To remove the module pull the module straight out

of the housing. (See Fig. 3-21)

Transferring a Secure Memory Module

NOTE: Make sure that when you move an SMM to

another instrument that you know what type of

instrument that will receive the SMM. For exam-

ple if you accidently place a Dispenser into a pre-

viously configured Filler, the Filler changes into

a Dispenser and vice versa. Make sure that you

know the type of instrument the SMM was taken

from.

CAUTION: D

O NOT REMOVE AN SMM WITH THE POWER

ON. ALWAYS DISCONNECT THE POWER CABLE FROM THE

INSTRUMENT BEFORE REMOVING OR INSTALLING THE

ECURE MEMORY MODULE.

Step 1. Disconnect the power cable from the Instrument.

Step 2. Remove the Secure Memory Module from the

instrument.

Step 3. Install the Secure Memory Module into the new

instrument.

Step 4. Power up the new instrument.