User Manual

ManualsBrandsHardy ManualsToolsHI 4050CW Check Weighing Bundle

FIG. 6 VERTICAL AND HORIZONTAL ORIENTATION

Ste p 2. When installing firmly push th e mounti ng fe et until y ou h ear a

snapping sound. The snap means they are mou nt ed correctly.

Step 3. After installation give each mounting foot a little tug to make

sure they are seated correctly.

NOTE: There are several horizontal and vertical mounting

options. It is highly reco mmen ded th at at least tw o

mounting feet be used per enclosure.

Step 4. To mount the enclosure onto a DIN rail. Place the mounting

feet on the DIN Rail and firmly press down un til the mounting

feet snap onto the rail.

Step 5. To remove the mounting feet use a finger o n t he clip and gen-

tly pull up on the tab.

NOTE: For Remote Display installation please see Chapter 3,

Installation, of the HI 4050 User’s Guide.

LOAD POINT INSTALLATI ON

FIG. 7 REAR PANEL

FIG. 8

Load Point Connectio n

Cable c olo r code for C2 Load Points (left to ri ght facing the rea r panel):

• Shie ld Gro un d Wire

•C2- Violet

•C2+ Grey

• EXC- Black

•SEN- Brown

• SIG- White

• SIG+ Green

•SEN+ Blue

•EXC+ Red

Step 1. Remove the factory installed jumpers from the terminal block

if you are connecting an 8 wire cable from the junction box.

(See Fig. 8)

Step 2. Connect the cable (Recommended load cell cable: Hardy

Instruments Part # 6020-0001) wires to the Weigh Scale Input-

terminal blo ck acc ord in g to the cabl e colo r chart.

Step 3. Plug the terminal block into the Weigh Scale Input connector

on the rear panel.

Step 4. For more information concerning C2 Lo ad Point connection,

consult Chapter 3, Installation, of the HI 4050 User Guide.

Non-C2 Load Point Connection

NOTE: Cable Col or Codes vary between vendors, check with your

supplier fo r the Colo r Code f or your Non -C2 load point . Do

not connect wires to the -C2 and +C2.

Step 1. Remove the factory installed jumpers from the terminal block

if you have a 6-wire load cell cable that includes sense wires

from the load cell or junction box.

Step 2. Connect the cable (Recommended load cell cable: Hardy

Instru ments Part # 6020-0001) wires to the Weigh Scale I nput

terminal blo c k accord in g to the manu fa ct urer’s specification .

Step 3. Plug the terminal block into the Weigh Scale Input connector

on the rear panel.