User guide

54 Chapter 5
•
•
•
•
•
•
• Modbus-RTU
o Slave Address
o Baud Rate
o Parity
o Termination
HI 6310 Only
• Printer
o Printer Mode
o Baud Rate
o Parity
• USB
oRestore
oSave
• Analog 4-20mA
o Weight Source
o Value 4mA
o Value 20mA
o mA Output
Ethernet TCP/IP Commands and Parameters
Enable DHCP Parameter
The Enable DHCP parameter enables the network to automatically assign an IP address
when DHCP is enabled in the HI 6300. When DHCP is disabled or the network is unable
to assign an IP address the Fixed IP address is used. Please note that DHCP works only if
there is a DHCP server installed on your network.
On the Web page , select the communication menu. Then select Ethernet TCP/IP, UDP and
select either Enable or Disable from the list next to the DHCP parameter.
On the HI 6300 series instrument display , select the communication menu and use the UP
or DOWN button to select the Ethernet TCP/IP submenu, then select the DHCP menu item.
The current state of the DHCP value will be displayed, press the ENTER if this value needs
to be modified. When modifying this parameter, the ENTER button toggles the parameter
between two states Enabled and Disabled, and pressing the LEFT button sets the state for
the Enable DHCP parameter.