User Manual

PanelInstallation:
1. Usetemplateprovidedtodrilltheholepatternintopanel.
2. Installthedisplayontothepanelusing4mmnutsandwashers,
tightenuntilgasketiscompressedanddisplaybezelcomesin
contactwiththepanel.Donotovertightenortheinstrument’scase
maycrack.
3. Connectthe
displaycabletodisplayandthentotheinstrument.
4. Slidetheinstrumentontothreadedrodsandsecureinplacewith
8mmx4mmretainingnutsusingan8mmnutwrench(donotover
tighteninstrumentretainingnuts,overtightingcouldcausethe
instrumenttocrack).

DINRailInstallation:
1. Use
templateprovidedtodrilltheholepatternintopanel
2. Installthedisplaypanelusing4mmnutsandwashers,tightenuntil
gasketiscompressed(4mmscrewstightenedwithan8mmnut
wrench)withalengthlengthappropriatetopanelthicknesscanbe
usedinplaceofthe4mmrods
sentwiththeunit).
3. PlacetheinstrumentontotheDINrail,slideDINrailclipupuntilit
snapsintoplacetosecure.
4. Connectthedisplaycabl etothedisplaypanelandinstrument
(legthenthecableasneededbyusingathinscrewdrivertorelease
andreplacewiresbetween
thetwoconnectors).