Owner manual

HI 6600 Series Modular Sensor System User Guide
Page | 107
Parameters
Parameters are the first listed hyper- link at the base of the
Diagnostics
page. Click that link to display the Parameters
page. Note the scroll bar
on the right of the list.
The steps below explain how you
can duplicate the
configuration of
one HI 6610 or HI 6600 to use in
configuring another HI 6610 or HI 6600 for sending a copy
of your
parameters to [e-mail]
To copy the parameters:
1) Right click in the
parameter list.
2) Click Select All.
3) Right click again.
4) Click Copy.
To paste the parameter configuration into the instrument you want to configure, or into a
text file for storage:
1) Enter the IP address of that instrument into a Web browser to display its Home
page.
2) Select Operation, then Diagnostics, then Parameters, as described above.
3) Right click in the Parameter list.
4) Click Select All.
5) Right click again in the Parameter List.
6) Click on Paste to replace the existing or default parameter settings with the
parameters settings of the
instrument you copied. Only the past setting from a text
file will work---you can not paste from a word
processing program.
7) Click the Save button. You now have an exact duplicate of the pre-configured
instrument.
If you need to make any modifications to the parameter settings go to Chapter 4, Configuration, for more
instructions.