Installation Manual

INSTRUCTIONS FOR ULTRAWELD

GROUNDING CONNECTIONS - CABLE TO GROUND ROD

Revised 1/11/05 Instruction Sheet GD

Place cable in the mold.

Cable must sit on top of

ground rod. Use locking

pliers or a clamp on the rod

below the mold to prevent it

from slipping when the

mold is fired.

Place cable into mold and secure mold to ground rod with backing plate

attachment. Support mold to keep it from sliding down the ground rod

when welding with locking pliers or clamp below mold.

Place end of tap cable under

center of tap hole. Run cable

must sit on top of the ground

rod. Use a pair of locking pliers

or a clamp below mold on

ground rod to support the mold

and prevent slipping.

Place cables in mold. Bottom

run cable must sit on top of the

ground rod. Use a pair of

locking pliers or a clamp below

mold on ground rod to support

the mold and prevent slipping.

STARTING POWDER

WELD METAL

STEEL DISK

WELD CAVITY

CABLE

GROUND ROD

Place end of cable under

the center of the tap hole.

Cable must sit on top of

ground rod. Use locking

pliers or a clamp on the

rod below the mold to

prevent it from slipping

when the mold is fired.

PAGE 1
INSTRUCTIONS FOR ULTRAWELD® GROUNDING CONNECTIONS - CABLE TO GROUND ROD GO GD STARTING POWDER Place end of cable under the center of the tap hole. Cable must sit on top of ground rod. Use locking pliers or a clamp on the rod below the mold to prevent it from slipping when the mold is fired. WELD METAL STEEL DISK WELD CAVITY Place cable in the mold. Cable must sit on top of ground rod. Use locking pliers or a clamp on the rod below the mold to prevent it from slipping when the mold is fired.
PAGE 2
GENERAL SAFETY INSTRUCTIONS 1. Always wear proper clothing, safety glasses and gloves when exothermic welding. 2. Only weld items that the mold is designed for. 3. Do not use worn or broken molds which could cause leakage of molten weld metal. 4. Make sure that the conductors being welded fits in the mold properly and that the mold will close tightly around them. 5. Do not alter molds or accessories without factory authorization. 6.