Manual

Page 12
Menu Mode
Menu mode gives access to the memory of stored readings and gives access to various options and
settings;
Show Stats
Gives access to the last 60 readings and various statistics
Clear all Stats
Clears all the stored readings/statistics
Display Size
Changes the Measurement mode display size from normal to large 
Display Average
Enables the running average during Measurement mode 
Frame Rate
Sets a frame rate to be used for calculation and display 
User ms Offset
Manually set a millisecond offset 
Speaker Dist
Set a speaker distance, an allowance is made for the distance of the
speaker in the readings

Mask Length
Adjust the Mast Time 
Detection Test
Used to check the detectors are picking up audio and video signals
Audio Trig Lvl
To adjust the sensitivity of the audio sensor 
Video Trig Lvl
To adjust the sensitivity of the video sensor 
Audio In Select
Changes the audio input selection 
Extended Mode
Enables / Disables Extended measurement mode
Auto Switchoff
Changes, or disables, the auto-off period 
Reset Settings
Resets all settings to default
System Info
Gives the serial number and any custom splash display
Firmware Upgrade
Used to activate the firmware upgrade mode
 The state/value of these options is stored in flash memory, so are retained if Sync-One2 is switched
off.
Within some menu options user input will be required, such as choosing between two options or
inputting values. Where user input is required, this is shown by displaying a flashing cursor near to the
requested action.
Options such as Yes/No, On/Off, or Large/Small, use the keys to toggle the input and
to select the input.
If values are required to be input, use the keys to increase/decrease the value, and
to confirm the value. For some menu items, holding the arrow key will step up or down in multiple
units.
↑ ↓
OK
↑ ↓
OK