User manual
Table Of Contents
- Table of contents
- 1 Safety instructions
- 2 Scope of delivery
- 3 Assembly instructions
- 3.1 Cut the headstock to size
- 3.2 Painting the body and neck
- 3.3 Mounting the tuners
- 3.4 Mounting the string retainer
- 3.5 Mounting the guitar neck
- 3.6 Mounting the pickguard
- 3.7 Wiring the potentiometers, pickups and switches
- 3.8 Mounting the bridge
- 3.9 Mounting the strap buttons
- 3.10 Strings, neck relief, string height and pickups
- 4 Protecting the environment
3.5 Mounting the guitar neck
Place the body on a suitable working surface. Use a soft pad in order to avoid
damage to the surface. Insert the neck into the neck cutout. If necessary, use a sharp
chisel or sandpaper to adjust it. Be very careful when removing material. The neck
should be rmly seated and under no circumstances should there be too much play
in the cutout!
Turn the bass guitar over and position the neck plate over the four screw holes at the
rear of the body, then screw the four wood screws provided through the neck plate,
body and pilot holes in the neck until everything ts tightly.
Assembly instructions
10
Bass Guitar Kit J-Style
Electric Bass Kit