User manual

3 Assembly instructions
Provide the following tools and materials for the assembly of the guitar:
n Phillips screwdriver
n Rubber mallet
n Ring spanner
n Pliers
n Paint and accessories
n Needle le
n Sandpaper
It is important to paint the body and neck before assembly.
Always wear a dust mask when applying spray paint.
3.1 Cut the headstock to size
Cut the headstock to your desired shape using a suitable saw. Ensure you leave su‐
cient space between the cutting edge and the holes for the tuners to maintain sta‐
bility. The tuners' retaining rings should be used as a reference here.
After cutting, smooth the cutting edge with sandpaper or a suitable le.
3.2 Painting the body and neck
The solid wood body of the guitar is sealed and prepared for various types of lacquer
coating. A wide variety of nishes can be procured from DIY, timber and automotive
outlets in aerosol cans making nishing straightforward without requiring specialist
skills.
The rst step is to check the t of the body to the neck joint. These components are
machined from high-grade tonewoods to ensure optimum alignment. Since wood is
a natural material, however, its shape changes slightly over time. If the t is too tight,
you can adjust it using a sharp chisel or sandpaper. Please remember that the addi‐
tional lacquer coat will make the neck t a little more tightly into the cutout.
Before coating the body, ensure that all surfaces are clean and free of dirt and dust.
Carry out all painting operations in a well-ventilated, dust-free environment. Consid‐
ered and careful working are key factors for a qualitatively satisfactory result. We
explicitly recommend that you rst try out the colour and technique on another
piece of wood.
Paint the body edges rst and let them dry. If the edges are dry, go on with front and
back side. By layered, successive application you can achieve a uniform coating struc‐
ture. If you notice surface irregularities, wait until the paint has dried completely and
correct them with ne sandpaper (e.g. 800+) before proceeding to paint. For full cov‐
erage apply three or more layers.
Insert a wire or hook into the cutout for the guitar neck and hang the painted guitar
body to dry in a dry, dust-free area away from direct sunlight.
Wait another two to three days until the paint is fully cured. Polish or burnish the
body until it meets your expectations. Take care not to bu too vigorously as this
may remove the nish.
Useful tools and materials
Painting the body
Assembly instructions
Bass Guitar Kit J-Style
7
Electric Bass Kit