User manual

The neck of the guitar is sealed at the factory with a thin layer of matt lacquer and is
already ready to use. However, if you would still like to treat the neck with paint or
clear lacquer, follow the instructions below.
Remove the ngerboard and all the frets cleanly before you start painting. Make sure
that all surfaces are free of dust and dirt. Carry out all painting operations in a well-
ventilated, dust-free environment.
Use a clear or lightly coloured wood lacquer of high quality for the neck. Start on the
front and the edges of the headstock. Apply a thin layer evenly, allow it to dry and
repeat this two or three times. If you notice surface irregularities, wait until the paint
has dried completely and correct them with ne sandpaper (e.g. 800+) before pro‐
ceeding to paint.
Once the headstock has dried, place the neck on the ngerboard and paint the back
of the neck as described.
Wait another two to three days until the paint is fully cured. Polish or burnish the
neck until it meets your expectations. Take care not to bu too vigorously as this may
remove the nish.
3.3 Mounting the tuners
From the front side of the headstock, insert the four sleeves for the tuners into the
holes provided.
Neck nish
Assembly instructions
8
Bass Guitar Kit J-Style
Electric Bass Kit