User manual

4.2 Body support mounting
Take the body support from the transport bag of the instrument and insert their ends
into the openings provided on the side of the body.
Make sure that the curvature of the body support points to the rear and that it sits
tension-free on the body. Tighten the bracket screws by turning them clockwise.
4.3 Mounting the bridge
On delivery, the strings of the instrument have minimum string tension between the
machine heads and the tailpiece on the fretboard. Remove the cable tie that secures
the strings for transportation.
Place the bridge in the holder provided on the top of the instrument body and set
the desired height using the two screws.
NOTICE!
Possible deformation
When adjusting the height of the bridge, excessive pretension can over‐
stretch the strings or damage the bridge or the top of the body.
On excessive tension, reduce the pretension of the strings or the height
of the bridge to avoid damaging the strings, the bridge or the top of the
body.
Make sure that all strings run correctly in the grooves of the bridge (the E string has
to run in the biggest groove).
You can then tune all strings with the machine heads using a tuner device to the cor‐
rect pitch (usually E, A, D and G).
Assembly instructions
DB01, DB02
11
Electric Upright Bass