Motorcycle User Manual

12
Assembly
T
M
• Fit the motor harness between the vehicle body tabs.
Motor
Harness
Ta b
Ta b
Top View
• Fit the tabs on the left footboard into the slots in the left
side of the vehicle frame. Make sure both tabs are in
the slots.
Hint: You may need to squeeze the left footboard in order
to align the tabs with the slots.
•Insert two #8 x
3
/4" screws into the left footboard as
shown. Tighten the screws.
Left
Footboard
Ta b
Ta b
Slots
4
5
T
M
• The right footboard was inserted in the vehicle frame at
the factory. Make sure the right footboard is in place.
•Insert two #8 x
3
/4
" screws into the right footboard
as shown. Tighten the screws.
Right
Footboard
6
• Separate the exhaust pipe set pieces. Note the
R (right side) and L (left side) markings on the inside
of each piece.
• Fit the inner half of the right exhaust pipe (R) over the
stabilizer wheel on the right side of the vehicle. Make
sure the peg on the inner exhaust pipe fits into the
hole in the vehicle body.
T
M
Stabilizer
Wheel
Vehicle
Body Hole
Right Exhaust
Pipe - Inner Half
Peg
7