Motorcycle User Manual

20
Assembly
.354 (Small Diameter)
Cap Nut
Fork Axle
• Place a .354 (small diameter) cap nut on a flat surface,
inside up. Fit the end of the fork axle into the cap nut.
•Tap the opposite end of the fork axle with a hammer to
secure the cap nut on the axle. Pull on the cap nut to
make sure it is securely assembled.
.354"
.354 Cap Nut
39
T
M
Steering
Stop
Neck of
Vehicle Body
• First, fit the tab on the steering stop into the curved slot
in the lower steering bushing .
• Hold the steering stop in place.
• Then, slide the handlebar assembly on the vehicle frame
neck and over the steering stop
.
Handlebar
Assembly
38
TM
Ta b
Handlebar
Harness
• Fit the handlebar harness behind
the tab in the vehicle frame neck.
See
Inset
Ta b
Handlebar
Harness
36
T
M
• Fit the remaining steering bushing onto the top of the
vehicle frame neck.
•Insert two #8 x
3
/4" screws into each end of the steering
bushing and tighten.
Steering
Bushing
37